ADTO Aluminum Formwork Components:

Components:

1. Wall panel

Wall panel and cylinder panel components. Standard wall panels and non-standard wall panels are both used.

2. Inner corner

Main components used to connect the wall panel.

3. Beam panel

Beam panel is the component used to connect the wall panel and the top wall panel.

4. End of the wall panel cover

It looks like a wall end panel, and it was set on the beam.

5. Wall panel

Use for top wall and have both standard and non-standard types.

6. Beam slab arch

Connect the wall panel and tower panel.

7. Middle beam

A beam used for floor building and it was used for connecting the wall panel when installing the floor.

8. Joint bar

Supporting materials when using Middle Beam and End Beam for installing the floor with props.

9. Floor inner corner

Inner component for connecting the wall panel and top floor panel.

10. Floor outer corner

Connect the wall panel and top floor panel.

11. Wall end panel

Used for the end of the wall panel. Forming the wall panel to a different type by pressing one side or two as a different angle.

12. Floor angle panel

Connect the wall panel and helpful discharge the wall panel. It can be fastened with nut when installing.

13. Prop

Supporting the weight of the floor panels during the concrete construction.

14. End Beam

Connect the wall panel when installing it. It is the component for the wall panel structure. It was installed at the end of the floor panel.

15. Prop Head

Connect the joint beam when installing the floor panel. It is a beam panel for floor structure. It was installed between two-floor panels. And it can unloading load for floor panel.

Accessories:

1. Round pin and wedge pin

Connect the wall panel and the floor panel

2. buckle panel

Use for fix level of the junction between two square panels.

3. Flat panel

It’s a material for maintaining some space(wall thickness)between the panel

4. PVC sleeve

Made of PVC, it will be needed when the flat steel bar protector is installed between two wall panels. With putting flat steel bar into the sleeve, then it can protect the bar in the concrete.

5. Crossing bolt

This accessory is used fixing inside and outside the wall panel, in case any wall distortion.

6. Square tube hook

Used to fix the replacement material in the horizontal bending part.